Shower Valve Repair in Edgewater, CO

Most Edgewater homes predate 1980, so a dripping or temperamental shower often has an older two-handle or early single-lever valve behind the trim. Many can be rebuilt with new stems, washers or cartridges; unsupported valves need replacing. Call the number on this page to be connected with a local plumber in Edgewater.

Edgewater, nicknamed "The Edge," is a small, fully urban city of about 2,300 households bordered by Denver, Lakewood and Wheat Ridge just west of Sloan's Lake. Its housing is old: Census survey figures put the median build year at 1958, with about 79% of homes built before 1980. That makes original compression valves and older supply piping common. The city buys water from Denver Water through six master meters and runs its own system. Denver Water's 2026 report lists average hardness of about 105 mg/L, and Denver Water uses chloramine. Edgewater homeowners own their water service line and meter.

What to do now

Close the main shutoff if water won't stop. The City's water and meter maintenance line is 720-763-3060.
Don't overtighten a two-handle valve. Cranking harder to stop a drip crushes the washer and damages the seat.
Note how many handles the shower has and whether the tub spout runs during showers.
Check the ceiling below an upstairs bath for stains.
Photograph the trim so the plumber can look for parts in advance.

Call now to be connected with a local plumber in Edgewater.

(303) 529-9880

Symptoms and likely causes

Symptom	Likely cause
Drip that needs more force each month	Hardened washer or pitted seat
Temperature jumps on a flush	Older valve with no pressure balancing
Low flow at the shower only	Old supply pipe or debris in the valve
Handle spins loosely	Stripped stem
Water stain below	Leak at the valve or nearby pipe

Cost factors

Rebuilding an old valve versus replacing it
Whether parts exist for a decades-old brand
Older pipe at the valve that may need replacing while the wall is open
Access through plaster or tile
A City of Edgewater plumbing permit for valve replacement; homeowners may pull their own only if they certify they will do the work and the property isn't for sale or rent

The number on this page connects you with an independent plumber who serves Edgewater. Say how many handles the shower has, roughly when the bathroom was last updated, and what has changed recently. In a house this age, the plumber may also suggest looking at the pipe running to the valve, since replacing a short run while the wall is open is usually simpler than coming back for it later.

Shower Valve Repair questions in Edgewater

Can an older two- or three-handle shower valve be rebuilt?

Often. With about 79% of Edgewater homes built before 1980, compression valves are common, and new stems, washers and seats can restore them if parts exist. Otherwise a single-lever valve replaces them.

Our house is decades old. What kind of shower valve is likely behind the trim?

Edgewater's median home was built in 1958, so expect a two- or three-handle compression valve unless the bathroom has been remodeled.

Is a permit needed to replace a shower valve here?

Edgewater's Building Department handles plumbing permits. Homeowners can pull their own only if they'll do the work themselves and the property isn't for sale or rent; work must meet the International Plumbing Code.

Why does the shower turn scalding or icy when someone flushes or runs water elsewhere?

Many older valves have no pressure balancing, so a flush changes the shower temperature. A new pressure-balancing valve fixes that.